Oh so many Jokes are going to follow about this one!! So to all of you with the bad minds
OK when I'm riding (My Bike) I seem to be putting a lot of pressure on my left wrist so even after short journeys my wrist gets sore. When I remember about it & take the weight off it not a problem till I go round the next sharp bend then starts over again!! On long journeys this is worse as by the end of a 5hr trip I can hardly pull in the clutch.
Anyone else had problems like this & how did you fix/stop it??
get yourself one of these http://www.iwantoneofthose.com/neon-pow ... index.html
great for building up the muscle in the forearm and wrists I used to have the same problem when I had my VFR and using this wee cadget worked for me
Bydand wrote:get yourself one of these http://www.iwantoneofthose.com/neon-pow ... index.html
great for building up the muscle in the forearm and wrists I used to have the same problem when I had my VFR and using this wee cadget worked for me
Save your money and start w@nking with your left hand.
It is not your wrists you need to build up but your abs you need to work on. That will help support your back better and take the weight off your wrists.
Also, on longer journeys you will probably notice a difference having got rid of that double bubble screen. At higher cruising speeds the airflow will now be lower so should help support your upper torso.
Big Kneed Al (master of the emergency stop & "stand up" comedian).
Keith might help you too, he showed me how to make the bike feel so light round the bends instead of having to fight it and in turn get sore bits. Maybe it's your riding technique
Lynners wrote:Keith might help you too, he showed me how to make the bike feel so light round the bends instead of having to fight it and in turn get sore bits. Maybe it's your riding technique
Allan
Lynners could have a point here - it could all be down to your throttle control.
To see what difference throttle controls makes, ride along a quiet straight and shut off the throttle, then move from one side of the road to the other. You should find the bike is slow to turn.
Now do the same again but maintaining a positive throttle (not accelerating, just keeping a constant throttle). You'll find the steering is a lot lighter and will change direction more quickly.
Thanks for all the replies I have about 1/2" on each side of my rear tyre but larger strips on the front!!
I am quite new to riding so it Prob is my technique & this is the first bike I have owned that you have to lean over the tank rather than sit straight.
I do need to sort out some lessons with Keith but looks like it wont be till after the wedding!!
Thanks Big Kneed Al (master of the emergency stop & "stand up" comedian) but this is also happening just coming into work!
Lynners wrote:Keith might help you too, he showed me how to make the bike feel so light round the bends instead of having to fight it and in turn get sore bits. Maybe it's your riding technique
Allan
Lynners could have a point here - it could all be down to your throttle control.
To see what difference throttle controls makes, ride along a quiet straight and shut off the throttle, then move from one side of the road to the other. You should find the bike is slow to turn.
Now do the same again but maintaining a positive throttle (not accelerating, just keeping a constant throttle). You'll find the steering is a lot lighter and will change direction more quickly.
Make sure that your clutch lever is not too high.
I had the same problem riding the FZR for extended runs and it turned out to be the clutch lever was too high and i was having to ride with my wrist bent back at an odd angle to operate the clutch. I adjusted the angle of the lever so that it was in line with my arm and the problem went away.
Might be worth checking.
clutch lever is a good idea .......
other one is riding position ... idea is to have no weight at all on your wrists, try finding a position where your supported entirely by bum, feet, knees, tank ........ elbows should be well bent, not straight. If you can do that, you may find that the bike steers a lot sharper as well ........
teamemmenracing wrote:clutch lever is a good idea .......
try angling the leaver down a little.
Or don't use the clutch.
Could also be a few other things, but mostly I guess the important things is to feel physically relaxed. Like your belly... think like that for your wrist... it's all in the mind
all good addvice if you lent over the tank you my need to pick up the pace a bitt so the wind takes your wait off your ristes. also if you brake aporching bends rather than changing down. try changing down more and bracking less :
A few people have told me its ok not to use the clutch when going up gears but to use it when going down. I just don't feel comfortable doing that! I feel that the clutch is there for a reason and I should use it.
I always use the clutch. My gears get a hard enough time without me adding to their woes and not using the clutch/ Not to mention the damage you can end up doing to the grear selector mechanism if you don't get the timing right!
Big Kneed Al (master of the emergency stop & "stand up" comedian).
Clutchless is OK if you get it right, and at the right times. I do use the clutch going up when riding slowly and in town. When getting a move on, and higher in the revs a couple of mm off-throttle and a toe forward results in a quick, smoth and positive change.
It works for me and I know that it has the potential to wear the selector ?guides? but I've never had a problem. Then again I don't tend to keep my bikes very long.
This is my take on it, I'm sure someone will have a different view.
Like Swampy, riding in town I always use the clutch to shift up.
When going slightly quicker I clutchless shift up most of the time. I tend to avoid clutchless shifting from 1st to 2nd as I find it too jerky.
Give it a try! If you keep an upward pressure on the gear linkage, when you start to roll off the throttle it will shift up a gear very smoothly allowing you to get back on the throttle.
swampy wrote:It works for me and I know that it has the potential to wear the selector ?guides? but I've never had a problem. Then again I don't tend to keep my bikes very long.
I used to have the same problem when I had my VFR and using this wee cadget worked for me 
