Hi all. Needing a bit of assistance with connecting my brake to my brake lever.
In the pic below you can see that the bit to clip onto the lever sits too low. I've tried moving it up but it does seem to be as high as it goes. Does anyone know if the bottom (clip part) can be removed? As I did get a new, shorter clip bit with the sets but after a good play around couldn't see how to get it off.
Cheers
Steve
Rear set/Brake help
-
- Tube steak
- Posts: 68
- Joined: Tue Jul 20, 2010 10:52 am
- Current Ride: 2015 R1200GSA
- Location: Aberdeen
- Zathos
- Mr Magpie
- Posts: 3161
- Joined: Sun Apr 27, 2003 10:46 pm
- Current Ride: Aprilia Tuono Factory R
- Location: Everywhere & Nowhere
Re: Rear set/Brake help
hold the U clip with a spanner and apply another spanner to the lock nut imediatly above the clip.
Once they are both lose you should be able to unscrew the old clip and replace it with the rearset clip.
Once they are both lose you should be able to unscrew the old clip and replace it with the rearset clip.
-
- Direct Access
- Posts: 31
- Joined: Fri Jan 06, 2006 5:57 pm
- Location: Aberdeen
Re: Rear set/Brake help
If its a road bike remember to make sure brake light is functioning correctly, as the switch may need adjusting.